日韩不卡视频在线观看一区_亚洲国产精品久久久久久6p_区三区日韩免费毛片_亚洲精品久久一区二区三区四区_精品国产电影久久官网_婷婷五月天视频_久久久国产成人片_婬乱久久久久_伊人久久大香线蕉av蜜芽_不卡在线中文字幕av

歡迎進入濟南濟柴環能燃?xì)獍l(fā)電設備有限公司官網!
當前位置:首頁 - 新聞中心 - 常見問題解答

常見問題解答

水輪發電機組運行維護要注意什么?

返回 2022.01.25 來源:http://m.pyucoin.com 0
(1)機組運行中,注意調速器油壓表與壓油槽油壓表的指示不能相差過大。
(1) During the operation of the unit, pay attention that the indication of the governor oil pressure gauge and the oil pressure gauge of the oil pressure tank shall not differ too much.
(2)機組在停機過程中,應盡量縮短低轉速運行時間。當轉速下降至額定轉速的35%~40%時,可加閘制動。
(2) During the shutdown of the unit, the operation time at low speed shall be shortened as far as possible. When the speed drops to 35% ~ 40% of the rated speed, the brake can be added.
(3)機組在運行中,導水葉的開度限制應放在機組大出力的限制位置。當機組起動與系統并列時,如發現調速系統不穩定,可用開度限制使其穩定。在與系統并列后,可將開度限制放在機組大出力限制的位置。
(3) During the operation of the unit, the opening limit of the guide vane shall be placed at the limit position of the maximum output of the unit. When the unit is started in parallel with the system, if the speed regulation system is found to be unstable, the opening limit can be used to make it stable. After parallel with the system, the opening limit can be placed at the position of the maximum output limit of the unit.
(4)定期檢查主軸的擺度。
(4) Regularly check the swing of the spindle.
(5)機組運行中,還應定期做如下工作:
(5) During the operation of the unit, the following work shall also be done regularly:
1)定期切換壓油裝置的油泵和導軸承油泵,以防電動機受潮。
1) Regularly switch the oil pump and guide bearing oil pump of the oil pressure device to prevent the motor from moisture.
焦化發電機組
2)調速器各杠桿的連接處要定期注油。
2) The connection of each lever of the Governor shall be filled with oil regularly.
3)各汽水分離器要定期放水。
3) Each steam water separator shall discharge water regularly.
4)定期清掃橡膠水導軸承潤滑水的過濾器。
4) Clean the filter of lubricating water of rubber water guide bearing regularly.
5)機組備用時,定期做橡膠水導軸承備用潤滑水的投入試驗。
5) When the unit is in standby, the standby lubricating water of rubber water guide bearing shall be put into test regularly.
6)定期向蝶閥軸承注油。
6) Fill the butterfly valve bearing regularly.
焦化發電機組專注為您提供新鮮的行業資訊,更多的問題及精彩內容請關注我們的網站:http://m.pyucoin.com,我們會有更多的精彩內容為您
Coking generator set focuses on providing you with fresh industry information. For more questions and wonderful contents, please pay attention to our website: http://m.pyucoin.com , we will have more wonderful content for you
新聞搜索
濟南濟柴環能燃?xì)獍l(fā)電設備有限公司
  • 服務熱線

    0531-62325028
    0531-69951266

水輪發電機組運行維護要注意什么?

(1)機組運行中,注意調速器油壓表與壓油槽油壓表的指示不能相差過大。
(1) During the operation of the unit, pay attention that the indication of the governor oil pressure gauge and the oil pressure gauge of the oil pressure tank shall not differ too much.
(2)機組在停機過程中,應盡量縮短低轉速運行時間。當轉速下降至額定轉速的35%~40%時,可加閘制動。
(2) During the shutdown of the unit, the operation time at low speed shall be shortened as far as possible. When the speed drops to 35% ~ 40% of the rated speed, the brake can be added.
(3)機組在運行中,導水葉的開度限制應放在機組大出力的限制位置。當機組起動與系統并列時,如發現調速系統不穩定,可用開度限制使其穩定。在與系統并列后,可將開度限制放在機組大出力限制的位置。
(3) During the operation of the unit, the opening limit of the guide vane shall be placed at the limit position of the maximum output of the unit. When the unit is started in parallel with the system, if the speed regulation system is found to be unstable, the opening limit can be used to make it stable. After parallel with the system, the opening limit can be placed at the position of the maximum output limit of the unit.
(4)定期檢查主軸的擺度。
(4) Regularly check the swing of the spindle.
(5)機組運行中,還應定期做如下工作:
(5) During the operation of the unit, the following work shall also be done regularly:
1)定期切換壓油裝置的油泵和導軸承油泵,以防電動機受潮。
1) Regularly switch the oil pump and guide bearing oil pump of the oil pressure device to prevent the motor from moisture.
焦化發電機組
2)調速器各杠桿的連接處要定期注油。
2) The connection of each lever of the Governor shall be filled with oil regularly.
3)各汽水分離器要定期放水。
3) Each steam water separator shall discharge water regularly.
4)定期清掃橡膠水導軸承潤滑水的過濾器。
4) Clean the filter of lubricating water of rubber water guide bearing regularly.
5)機組備用時,定期做橡膠水導軸承備用潤滑水的投入試驗。
5) When the unit is in standby, the standby lubricating water of rubber water guide bearing shall be put into test regularly.
6)定期向蝶閥軸承注油。
6) Fill the butterfly valve bearing regularly.
焦化發電機組專注為您提供新鮮的行業資訊,更多的問題及精彩內容請關注我們的網站:http://m.pyucoin.com,我們會有更多的精彩內容為您
Coking generator set focuses on providing you with fresh industry information. For more questions and wonderful contents, please pay attention to our website: http://m.pyucoin.com , we will have more wonderful content for you
成人激情视频在线观看| 狠狠操观看视频| 韩国精品视频在线观看| 自拍视频亚洲无码| 玖玖蝌蚪| 1769视频精品| A级黄片免费视频| 91色在线播放| 色情无码免费视频网站在线观看| 亚洲国产网站| 亚洲av无码精品蝌蚪| 精品色宗合网战| 国产私伦一区二区三区网站| 欧美一区二区三区AA大片漫| 关之琳| 亚州AV| 成人aV一区二区三区| 不卡视屏一区| 欧美日韩国产精品一区二区| 秋霞午夜影院| 国产精品久久精品| 国精产品一区二区三区黑人和中国 | 国产精品超碰| 一级大片网站| 日韩成人91小电影| 亚洲夜夜爽| 国产性生活手机在线视频免费视频观看| 青青草原Av| 欧美福利视频| 一级久久| 国产精品婷婷| 黄网站在线免费看| 日本伊人激情| 天天操人人爱| 那种AV网站| 拳交网| 亚洲无码高清在线| 久久激情网| 久久在线视频| 精品视频在线观看999| 99久久精品免费视频|