近年來，隨著社會的發展，人們對環保的意識也在不斷地提高。燃氣發電機組作為一種環保性比較強的發電機組深受人們的喜愛。燃氣發電機組在使用時有什么要求呢？

In recent years, with the development of society, people's awareness of environmental protection is constantly improving. As a kind of generator set with strong environmental protection, gas generator set is deeply loved by people. What are the requirements for the gas generator set in use?

燃氣發電機組使用燃氣的要求

Requirements for the use of gas for gas-fired generating units

燃氣發電機組的燃料以沼氣為主，也可以使用油田伴生氣、液化石油氣、燃氣等可燃性氣體。所用的氣體應通過干燥脫水，達到無游離水、原油和輕質油，其低熱值不應低于31.4mj/m3,總硫含量不大于480mg/m3,硫化氫含量不大于20mg/m3.此外燃氣輸送壓力在0.08－0.30MAP范圍內。

The fuel of the gas-fired power generation unit is mainly biogas, and combustible gases such as oil field associated gas, liquefied petroleum gas and gas can also be used. The gas used shall be dried and dewatered to be free of free water, crude oil and light oil. Its low calorific value shall not be less than 31.4mj/m3, total sulfur content shall not be greater than 480mg / m3, and hydrogen sulfide content shall not be greater than 20mg / m3. In addition, the gas transmission pressure shall be within the range of 0.08-0.30map.

燃氣發電機組使用冷卻液

Coolant used for gas generator set

用于冷卻系統的直接冷卻發動機的冷卻液通常使用清潔的淡水，雨水或經澄清的河水為宜。當燃氣發電機組在低于0度的環境條件使用時，應嚴防冷卻液凍結，致使零件凍裂。可根據溫度來配用適當凝點的防凍液或在起動前加注熱水，但停車后應立即放水。

Clean fresh water, rain water or clarified river water are usually used as the coolant for the direct cooling engine of the cooling system. When the gas-fired generator set is used under the environmental conditions below 0 ℃, the cooling liquid shall be strictly prevented from freezing and causing parts to freeze. Antifreeze with proper freezing point can be added according to the temperature or hot water can be added before starting, but water shall be drained immediately after shutdown.

燃氣發電機組所用的機油

Oil for gas generator set

燃氣發電機組的運動件并對這些運動件起到冷卻散熱、帶走雜質和防止銹的作用。其品質的好壞除對燃氣發電機組的性能和使用壽命有影響外，對機油的使用期限有一定的影響。為此，應根據燃氣發電機組的使用環境溫度來選適當的機油。

The moving parts of the gas generator set play the role of cooling and heat dissipation, removing impurities and preventing rust. The quality of the oil not only affects the performance and service life of the gas generator set, but also has a certain impact on the service life of the oil. Therefore, the proper oil shall be selected according to the operating environment temperature of the gas generator set.

此外發電機組的燃氣在使用前，應經過預處理（如過濾、氣液分離、穩壓等）。溫度過高時，還應采用冷卻器冷卻，以保證燃氣中沒有液態成分。針對不同燃氣，處理的流程也不同。若氣源壓力不足，發電機組雖能正常啟動，但可能達不到標定功率。所以用戶在選購機組前，應提供氣體成分和壓力，以便公司提供適宜的產品。

In addition, the gas of the generator set shall be pretreated before use (such as filtration, gas-liquid separation, pressure stabilization, etc.). When the temperature is too high, the cooler shall also be used for cooling to ensure that there is no liquid component in the gas. The treatment process is different for different gas. If the air source pressure is insufficient, the generator set can be started normally, but it may not reach the rated power. Therefore, before purchasing the unit, the user should provide the gas composition and pressure so that the company can provide appropriate products.

以上就是小編介紹燃氣發電機組對燃氣等方面的因素做的相關要求，您有需求購買或者安裝使用的話就來我們網站http://m.pyucoin.com咨詢了解看看吧。

The above is the relevant requirements of the gas generator set for gas and other factors. If you need to purchase or install, please come to our website http://m.pyucoin.com Consult and understand.