一、啟動前的日常保養

1、 Daily maintenance before startup

清潔檢查

Cleaning inspection

徹底清潔發電機組表面，確保無油污、灰塵堆積。

Thoroughly clean the surface of the generator set to ensure no oil stains or dust accumulation.

冷卻系統檢查

Cooling system inspection

檢查水箱防凍液液面，應保持在水箱蓋焊點下方5cm處，嚴禁超過上限。

Check the coolant level in the water tank, which should be kept 5cm below the welding point on the water tank cover, and it is strictly prohibited to exceed the upper limit.

檢查水箱散熱片及冷凝器內部，確保無雜物堵塞。

Check the radiator fins of the water tank and the interior of the condenser to ensure that there are no debris blockages.

空氣濾清器檢查

Air filter inspection

若阻塞指示器顯示在藍色區域，需停機并立即更換濾清器，禁止重復使用舊濾芯。

If the blockage indicator displays in the blue area, stop the machine and immediately replace the filter. Do not reuse the old filter element.

潤滑油檢查

Lubricating oil inspection

檢查發動機機油油位，確保液面在機油尺最小與最大刻度之間。

Check the engine oil level to ensure that it is between the minimum and maximum marks on the dipstick.

電氣系統檢查

Electrical system inspection

檢查控制系統機電連接線，確保無松動或接觸不良。

Check the electromechanical connection wires of the control system to ensure that there is no looseness or poor contact.

二、運行結束后的日常保養

2、 Daily maintenance after operation

緊固檢查

Tightening inspection

重點檢查并緊固旋轉部件螺母（如高壓油泵、水泵、齒輪、風扇等），同時加固地腳螺栓。

Focus on inspecting and tightening the nuts of rotating components (such as high-pressure oil pumps, water pumps, gears, fans, etc.), while reinforcing the foundation bolts.

泄漏檢查

Leakage inspection

檢查是否存在漏油、漏水、漏氣現象，必要時進行修復。

Check for oil, water, and gas leaks, and repair if necessary.

故障排查

Troubleshooting

記錄運行過程中出現的異常現象或故障，及時分析處理。

Record any abnormal phenomena or faults that occur during operation, and analyze and handle them in a timely manner.

濾清器維護

Filter maintenance

清潔空氣濾清器濾網，去除積塵。

Clean the air filter mesh and remove dust accumulation.

油液補充

Oil replenishment

檢查機油液面及高壓油泵油位，必要時添加符合技術標準的高品質機油。

Check the oil level and high-pressure oil pump level, and add high-quality engine oil that meets technical standards if necessary.

檢查水箱冷卻液液位，必要時補充軟化水或防凍液。

Check the coolant level in the water tank and add softened water or antifreeze if necessary.

電氣系統復查

Electrical system review

再次檢查控制系統接線，確保無松動或老化。

Recheck the control system wiring to ensure there is no looseness or aging.

清潔整理

Cleaning and tidying up

全面清潔發電機組表面，保持設備整潔。

Thoroughly clean the surface of the generator set and keep the equipment clean.

本文由沼氣發電機友情奉獻.更多有關的知識請點擊:http://m.pyucoin.com我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

This article is a friendly contribution from a biogas generator For more information, please click: http://m.pyucoin.com We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message