燃氣發電機充分利用各種天然氣或有害氣體作為燃料，變廢為寶、運行安全方便，成本效益高，排放污染低，并適宜熱、電聯產等優點，市場前景十分廣闊。當然使用時的一些事項要考慮到才行。

The gas generator makes full use of various natural gas or harmful gas as fuel, which has the advantages of turning waste into treasure, safe and convenient operation, high cost-effectiveness, low emission pollution, and suitable for heat and electricity cogeneration. The market prospect is very broad. Of course, some matters should be taken into consideration when using.

1、燃氣發電機組機房應遠離明火區域；

1. The gas generator unit room shall be away from the open fire area;

2、燃氣發電機組機房應寬敞、明亮且要求安裝換氣扇以保證良好的通風；

2. The gas generator unit room shall be spacious and bright, and ventilation fans shall be installed to ensure good ventilation;

3、燃氣發電機組安裝時底盤與地基應用平墊鐵找平。接觸面積應在60%以上，且分布均勻；

3. During the installation of the gas generator set, the chassis and the foundation shall be leveled with a flat pad iron. The contact area shall be more than 60% and evenly distributed;

4、室內安裝照明、開關、線路及其電器應采用防爆措施,且固定牢固；

4. Explosion proof measures shall be taken for indoor lighting, switches, lines and electrical appliances, and they shall be firmly fixed;

5、燃氣發電機組機房內應符合消防要求，配備滅火器等消防器械；

5. The gas generator set room shall meet the fire-fighting requirements and be equipped with fire extinguishers and other fire-fighting equipment;

6、燃氣發電機組機房內安裝可燃氣體報警裝置，可燃氣體泄露時能及時發現；

6. A combustible gas alarm device is installed in the machine room of the gas-fired generator set to detect the leakage of combustible gas in time;

7、60kw以下單臺燃氣發動機燃氣管路的外部主要管道內徑應不小于2吋，靠近發動機的部分內徑應不小于1吋。60kw以上燃氣發電機組則分別是3吋和兩吋。且須安裝燃氣閥門（不銹鋼球閥）、型放水閥、防回火裝置，燃氣管路焊接完成應清理焊渣（用高壓空氣）；

7. The inner diameter of the external main pipeline of the gas pipeline of a single gas engine under 60kW shall not be less than 2 inches, and the inner diameter of the part near the engine shall not be less than 1 inch. The gas-fired generating units above 60 kW are 3 inches and 2 inches respectively. Gas valve (stainless steel ball valve), type drain valve and anti backfire device shall be installed. After welding of gas pipeline, welding slag shall be cleaned (with high-pressure air);

8、燃氣須脫硫、脫水、除塵，其中含流量≤0.25Nm3，氫氣≤10%。

8. The gas must be desulfurized, dehydrated and dedusted, including flow ≤ 0.25nm3 and hydrogen ≤ 10%.

使用燃氣發電機組工作要考慮相關事項的內容就講解到這里了，您對此有什么想了解的，可以隨時來我們網站http://m.pyucoin.com進行咨詢了解！

This is all about the matters to be considered when using the gas generator set. If you want to know anything about it, you can come to our website at any time http://m.pyucoin.com Consult and understand!