焦化發電機組使用有兩種停機的情況，一種是正常停機，另一種是遇到其他異常情況時候緊急停機。正常停機方法：先將空氣開關關閉，讓焦化發電機組由高速調到低速，讓機器怠速3~5分鐘，然后關閉。焦化發電機組運行時，出現如下幾種異常情況之一的，必須緊急停機：

There are two kinds of shutdown conditions for coking generator unit, one is normal shutdown, and the other is emergency shutdown in case of other abnormal conditions. Normal shutdown method: first turn off the air switch, let the coking generator set change from high speed to low speed, let the machine idle for 3~5 minutes, and then turn off. Emergency shutdown is required in case of one of the following abnormal conditions during the operation of coking generator unit:

1、機油壓力低或冷卻水水溫高，故障燈亮為紅色；

1. If the oil pressure is low or the cooling water temperature is high, the fault light will be red;

2、焦化發電機組頻率表讀數超過的55Hz，或說是轉速超過1650rpm時；

2. When the frequency meter reading of coking generator unit exceeds 55Hz, or the rotating speed exceeds 1650rpm;

3、機組運行發出急劇、異常的敲擊聲；

3. The unit operation sends out sharp and abnormal knocking sound;

4、機組出現零件損壞，可能造成機組某些部件損壞的；

4. Parts of the unit are damaged, which may cause damage to some parts of the unit;

5、氣缸、活塞、軸瓦、調速器等運行部件卡死時；

5. Cylinder, piston, bearing bush, governor and other operating parts are stuck;

6、機組輸出電壓超出表上的大讀數時。

6. When the unit output voltage exceeds the large reading on the meter.

焦化發電機組運行中遇到像是可能危害到機組、操作人員安全的事件(漏電、火災等自然災害)時候，也要緊急停機。焦化發電機組緊急停機方法：緊急情況拍下紅色緊急停機按鈕，同時該指示燈會亮。

Emergency shutdown is also required in case of events (such as electric leakage, fire and other natural disasters) that may endanger the safety of units and operators during the operation of coking generator units. Emergency stop method of coking generator unit: in case of emergency, take the red emergency stop button and the indicator light will be on.

如果對于異常故障情況不能時刻關注的，建議搭配四保護系統或ATS控制柜使用。廠家http://m.pyucoin.com提醒您，還要注意正確的操作方法以及機組的定期清潔保養工作。

If it is impossible to pay attention to abnormal fault conditions at all times, it is recommended to use it with four-protection system or ATS control cabinet. manufactor http://m.pyucoin.com You should also pay attention to the correct operation method and the regular cleaning and maintenance of the unit.